Marzocchi "Bomber Z1 Coil" Plunger & Top Cap Conversion Kit - 27.5 inch
-
Weight : 0.1kg / 0.22lbs
Weight
The heaviness of a BMX part, measured by weighing. It's worth noting that weight specifications for BMX parts can vary and may not always be precise. Several factors contribute to this:Manufacturer's weight specifications may be inaccurate or incomplete.The weight of two identical parts can also differ.We cannot weigh every individual part.For example, if there are handlebars in different heights, the manufacturer usually provides just one weight specification for all heights. When weighing two identical tires, you might get two different results.Source: BMX Glossary
- Packaging Unit: 1 Set
- Product ID (PID): 42670
- Product safety
Found an error? Report it. 5 EUR voucher if confirmed.
The Marzocchi "Bomber Z1 Coil" Plunger & Top Cap Conversion Kit - 27.5 inch converts a Marzocchi Bomber Z1 with air spring to the coil spring of the Z1 Coil. The kit replaces the plunger and top cap of the air spring; afterwards the fork runs on a coil spring with the supple response that comes with it. Riders already on a Z1 Coil get the matching parts for service or tuning here. The coil spring itself is not included and is needed separately.
Facts: Marzocchi "Bomber Z1 Coil" Plunger & Top Cap Conversion Kit - 27.5 inch
- Fits: Marzocchi Bomber Z1 forks, 27.5 inch, up to 180 mm travel
- Version: plunger & top cap kit for coil spring, 180mm
- Contains: plunger shaft, top cap and the parts shown on the manufacturer photo (guide sleeve, red clips)
- Extras:
- turns a Bomber Z1 with air spring into a Z1 Coil
- coil spring (Bomber Z1 Coil Conversion Spring) not included, required separately
- Marzocchi part number 820-03-664
These details come from manufacturer and supplier data. Found an error? Report it, there is a 5 EUR voucher for every confirmed error.
